Usually, the installer who terminates the cable has the job of labeling each termination point. Ideally, the label has been created as part of the design of the cable network and that the installer only has to attach the color codes of the fibers to the label and, if not yet attached, paste the label on the panel Connection in the right place. This is an important process since the designation of each fiber will be used to record the test information, the connection to the equipment and will continue during future movements, additions, and modifications. The doors of the connection panels should have signed with the specifications of use and warnings about the person authorized to enter.
Cleaning the work area
After termination or splicing of the cables, the installer should carefully clean the work area and leave it as clean as he found it, preferably cleaner than he found it. All remains, especially fibers, which should be sealed in disposable containers, must be removed from the area.
Storage of leftover components
Any component that must be saved for future use. The connectors and cables can be stored together with the wiring documentation so that in the event of restoration in the future, compatible components are available for use in splicing or terminating the cables.
optic cable installers
Cleaning the work area
After termination or splicing of the cables, the installer should carefully clean the work area and leave it as clean as he found it, preferably cleaner than he found it. All remains, especially fibers, which should be sealed in disposable containers, must be removed from the area.
Storage of leftover components
Any component that must be saved for future use. The connectors and cables can be stored together with the wiring documentation so that in the event of restoration in the future, compatible components are available for use in splicing or terminating the cables.
optic cable installers
No comments:
Post a Comment